Replacement Rotary Blade Clamp for Mk.IV Saws
Price
¥310.00
Excluding Tax and Shipping
这套替换实心刀片夹（美国制造）适用于较新的 Mk.IV 线锯/珠宝锯
Product Details
这套替换实心刀片夹（美国制造）适用于较新的 Mk.IV 线锯/珠宝锯。它们不适合 Mk.III 锯或钢丝锯。
Replacement instructions
Use a 5/64-inch Allen wrench to loosen the set screw in the saw handle end clamp and remove the clamp.
Replace the fixture with a new one and retighten the set screws. Note the position of the brass knob on the front/upper old fixture screw.
Unscrew the brass knob from the old upper/front fixture and remove it.
Unscrew the brass knob from the new jig, thread it through the hole in the shaft (if you have a lever saw), and put the brass knob back on the end of the screw.
Adjust until the blade can be properly tensioned. Start by placing the new knob in approximately the same position as the old knob. If you see any screws protruding from the back of the brass knob, it is too tight.
Made in the USA.
Replacement instructions
Use a 5/64-inch Allen wrench to loosen the set screw in the saw handle end clamp and remove the clamp.
Replace the fixture with a new one and retighten the set screws. Note the position of the brass knob on the front/upper old fixture screw.
Unscrew the brass knob from the old upper/front fixture and remove it.
Unscrew the brass knob from the new jig, thread it through the hole in the shaft (if you have a lever saw), and put the brass knob back on the end of the screw.
Adjust until the blade can be properly tensioned. Start by placing the new knob in approximately the same position as the old knob. If you see any screws protruding from the back of the brass knob, it is too tight.
Made in the USA.