This set of replacement solid blade clips is for use only with the
Newer (post 2010) Mk.III saws
. They do not apply
use for
Older (pre-2010) Mk.III saws, Mk.IV heavy duty saws, titanium (birdcage) saws or wire saws.
Replacement instructions
Use a 5/64-inch Allen wrench to loosen the set screw in the saw handle end clamp and remove the clamp.
Replace the fixture with a new one and retighten the set screws. Note the position of the brass knob on the front/upper old fixture screw.
Unscrew the brass knob from the old upper/front fixture and remove it.
Unscrew the brass knob from the new jig, thread it through the hole in the shaft (if you have a lever saw), and put the brass knob back on the end of the screw.
Adjust until the blade can be properly tensioned. Start by placing the new knob in approximately the same position as the old knob. If you see any screws protruding from the back of the brass knob, it is too tight.
Made in the USA.